The cycloidal pinwheel reducer can continue to operate 10OH after the first refueling. After that, the new oil needs to be replaced, and the internal residual oil must be rinsed before the oil change, so as to ensure the quality of the new oil. The second oil change can be done after half a year of use. The premise is that the reducer runs for 8 hours a day. If the working time exceeds 8 hours a day, or the environmental condition of the reducer is relatively poor, you must flexibly grasp the oil change time. Replace every month to five months. When the reducer is in use, always add lubricating oil to ensure continuous operation of the machine.

　　 The concentricity of the cycloid pinwheel reducer coupling should be regularly tested and inspected to ensure that it meets the standards and avoid any damage to the reducer equipment due to non-torque force.

　　 Perform regular inspections of the fixing bolts, and tighten the bolts that are loose in time to prevent them from falling off during operation. If the reducer often has swing problems during operation, or the strength of the movement is unbalanced, it is necessary to check whether the anchor bolts are loose and take timely reinforcement measures.

It is also necessary to carefully check the oil level on time and do a good job of changing the oil in time. When changing the oil, keep the inside of the equipment clean and clean up the original oil stains. It is best to check whether there are worn iron filings and gearboxes. The washing machine uses the original oil supply and discharge system of the gear box and the filtered old oil to realize the functions of cleaning the gear box, quickly filtering waste oil, and filling new oil. The operation process does not change the hardware facilities and does not add cleaning agents. , To ensure the safe operation of the gearbox and prolong the service life. If it is not removed, it will easily affect the service life of the working surface and the bearing. When injecting special grease, pay attention to ensuring sufficient injection volume and quality. Therefore, it is best to keep the working environment clean and tidy. Do not let dust enter the lubricating oil. Check whether the shaft diameter sealing ring of the reducer is aging or worn, and replace the new sealing ring in time to ensure the quality of the seal.

       When the cycloid reducer is operating normally, if the temperature rises too fast, or even exceeds 70°C, it is necessary to check whether the internal components of the reducer have problems in time. If the temperature is normal but there are abnormal noises, open the reducer and carefully check whether the bearings, pins, pin sleeves and cycloid discs have obvious wear or damage, and replace and repair them in time. Cycloidal pinwheel reducer is changing

When replacing an eccentric bearing, two crowbars are usually used to apply force. The crowbar is placed in the middle of the eccentric bearing. It can be easily removed by using a balanced force at the corresponding points on both sides. Avoid unilateral Use force and do not knock, which will cause the shaft to be eccentric or the cycloid disk to be damaged.