Contact Us

Fax:+86-571-88220227

Mail:[email protected]

Add:No. 2, Longshen Cdc, Sandun Town, Hangzhou, Zhejiang, China

Home > News > Content
Installation And Lubrication Of Cylindrical Gear Reducer May 27, 2020

Installation and Lubrication of Cylindrical Gear Reducer. 

I. installation. 

1. The cylindrical gear reducer generally needs to be installed on the horizontal plane with an inclination of no more than 10 °. If the inclination is greater than 10 °due to special needs, please contact our company before use in order to discuss the relevant matters together. 

2. When the input shaft and output shaft are connected with power and supporting machinery, if the shaft is connected with a coupling, the shaft and shaft are required to be strictly centered, and there should be no concentric phenomenon, and the use of triangular belts and chains should not be too tight or too loose. 

3. The installation foundation should be firm and reliable, there should be no vibration or loosening, and the fixing screws should be selected strictly according to the relevant standards and regulations. 

4. The installation screws should be checked from time to time to see if they are tightened and firmly fixed, and the gasket should be spring gasket as far as possible. 

Second, lubrication. 

1. Gear reducers are generally lubricated with oil pools. Before use, be sure to add medium extreme pressure gear oil N220 or N320 to the specified position (20-30mm at the lowest tooth) and replenish it regularly. 

2. After using it for 50 hours for the first time, the new oil should be replaced immediately, and the oil stain inside the body should be cleaned, and then it should be replaced thoroughly every three months. 

3. Please replace the oil seal by yourself as soon as possible.