Contact Us
Fax:+86-571-88220227
Mail:[email protected]
Add:No. 2, Longshen Cdc, Sandun Town, Hangzhou, Zhejiang, China
Vacuum Pump System Mar 19, 2020
Lay reinforcing materials on the surface of the mold, then place auxiliary materials such as vacuum bags, and extract the air in the system to form a negative pressure between the vacuum bag and the mold cavity. Use the pressure generated by the vacuum process to pass the resin through the pre-paved The pipeline is pressed into the reinforcing material, so that the resin infiltrates the reinforcing material and finally fills the entire mold. After the product is cured, the auxiliary material is removed to obtain the desired product from the mold.
Related News
- The Structure Of Chain Wheel Design
- The Basic Data For Electric Motors
- What Is Speed
- Installation Site Selection
- The Main Purpose Of Air Compressor
- Characteristics Of Air Compressor
- Composition Of Air Compressor
- What Is An Air Compressor
- Application Fields Of Vacuum Introd...
- Advantages Of Vacuum Introduction P...
- Common Faults And Treatment Methods...
- Water Ring Vacuum Pump Operating Pr...
- How Does The Synchronizer In A Car ...
- What Does The Gearbox Do
- What Is The Specific Role Of Car Tr...
- What Is The Function Of A Car Gearbox
- What Is The Function Of Tractor And...
- Vacuum Pump Drive Mode
- General Structure And Transmission ...
- Type Of Vacuum Pump