Weasler 12 Series PTO Shaft Driveline Replacement Tractor PTO Drive Shaft

What is Weasler 12 Series PTO Shaft?

 

Driveline

• 1-3/8″-6 Spline Spring-Lok Tractor Yoke
• Outside Diameter: 6.00 inches
• Extended Length：69.75 inches
• Extended Overall Lengt: 77.87 inches
• Requires Implement Yoke.
• 19 HP @ 540 RPM     29 HP@1000RPM
• 48″ Compressed Length (Dim. A)
• Weight: 23.70 pounds
• Connection: YOKE ARMS

 

 

How to Measure Parts of the PTO shaft

Correct measurement of shaft parts is crucial for selecting the correct PTO series size. Each piece needs to be measured in a specific way to meet standard dimensions. Follow the steps below to ensure that the correct measurements are obtained and to order parts suitable for the tractor.
1. Measuring shaft
To measure your shaft, you should first ensure that it is in the closed position, where the shaft is the smallest. Use a tape measure to record the outer length of each yoke. This measurement is the closing length. Use this measurement to find the correct series size for the tractor horsepower.
Make sure you also know if there are safety pins, clutches, or spline implement ends.
2. Measure the universal joint
When measuring a universal joint, measure the length from one end to the other. You also need to record the width of one end of the universal joint. Use these numbers to find the right size universal joint.
3. Comprehensive consideration
You need the two measurements listed above to find a suitable and functioning PTO shaft part for the tractor. You can use the PTO yoke size chart to obtain the correct size, or you can use our convenient PTO series discovery tools.

How to Identify the Series of Agricultural PTO Driveline

 

Identifying the series of an agricultural PTO driveline can be done by following these steps:

1. Determine the Size: Measuring the size of the driveline is the first step. You will have to measure the width of the yokes on each end of the driveline. Once you have that measurement, then compare it with the chart of driveline sizes, which is easily available online.
2. Count the Spline Number: The spline number is the number of teeth or grooves on the yokes that interlock to transmit power. Count the number of splines on each yoke, and compare it with the chart of standard spline sizes.
3. Check for Collapsed Length: The compressed length is the length of the driveline when it is fully compressed. This length is measured from the end of the yoke to the center of the cross kit. You should check the compressed length of your PTO driveline to make sure it matches the chart of standard dimensions.
4. Check for Operating Angle: The angle at which the driveline operates is an essential factor to consider while identifying the series of the driveline. You should determine the angle at which the driveline operates and compare it with the chart of standard angles.

By following these steps, you can easily identify the series of an agricultural PTO driveline.